Interested to Buy Any Domain ? << Click Here >> for more details...
What is the difference between circuit and network.
- 15 Answers
- 70781 Views
- Jadavpur University, Sail, TCS, I also Faced
- E-Mail Answers
Answer Posted / vinutha
network is a open loop whereas circuit is a closed loop.
for example if we take a building then the building is a network and rooms in it are circuits.
or simply we can say that combination of circuits is a network
| Is This Answer Correct ? | 4 Yes | 2 No |
Post New Answer View All Answers
why we use single core 630mm2 cable for transformer secondary side
How much earthing frequency is capable?
how to calculate percentage impedence at 75 deg C at normal tap
54 Comments Alok and Bhanu play the following min-max game. Given the expression N = 38 + X*(Y – Z) where X, Y and Z are variables representing single digits (0 to 9), Alok would like to maximize N while Bhanu would like to minimize it. Towards this end, Alok chooses a single digit number and Bhanu substitutes this for a variable of her choice (X, Y or Z). Alok then chooses the next value and Bhanu, the variable to substitute the value. Finally Alok proposes the value for the remaining variable. Assuming both play to their optimal strategies, the value of N at the end of the game would be?
how to calculate current carring capacity of cable and cable selection? 1) copper flexible cable 2) copper armoured cable 3) Aluminium cable
what is zinc diffusion?
how to find the resistance and gap volatage of the diode??
Why we use 4-20 mA Analog signal for the PLC input? Why not 0-20 mA? Why not 5-25 mA?
if sf6 gas low in gis what will happen
What is the effect on in Zone and out zone fault if Phase side CT is Vk/2<30 mA and Neutral side is CT is Vk/4<30 mA for Transformer REF protection
what is DRP panels?
Hello seniors m an engineering student in 3rd yr..i want to know what are the software course in electrical field?i wanted to do certification course but i dont know much about the course?..Regards
What is time response of the control system?
In radial network the source is fed from 1 end both ends at central
how technical is calculated in 11kv line and lt line
