Interested to Buy Any Domain ? << Click Here >> for more details...
if single phase is having 220v supply then why three phase is having 440v instead of 660v?
- 4 Answers
- 8348 Views
- C&S, NTPC, I also Faced
- E-Mail Answers
Answer Posted / sanjeev
voltage means potential difference between two points. In case of single phase potential difference between phase and neutral is 220v.
in case of three phase(R,Y,B) potential difference between R & Y is 220 and Y& B is 220
Hence the voltage offered by a three phase(LT) system is potential difference between Three phases i.e. 220+220=440 volts.
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
Is it required to lay 2 runs of GI wires along with armoured cables from one power DB Machines of higher rating?
How can we connect additional batteries to three phase ups? What are parameters we have to check when connecting?
How to findout raw or ups power? its not indicated in socket,
How many energy meters can be connected on a 15VA Voltage transformer. please send a calculation sheet.
What is thresh hold value of current?
why in the three pin plug all 3 pins are cutted ?
how ct burden,magnetising current,ratio and knee point voltage are related & derived
CAN CU XLPE/PVC CABLE BE USED INPLACE OF LOW NOISE SCREENED CABLE? KINDLY GIVE REASONS
can we use NPT glands in LT panel
In single phase ac ups supply when current is measured with tong tester neutral current is found more than phase current.What is the reason?
What is corkscrew rule?
how can found motors folt current ? how can disided circuit breakers caoicity and breaking capicity ?
After taking shutdown of 11kv feeder, if you see 5kv by phasing stick in the cable side, is it possible to close earth switch in cable.
Zone of protection and tripping scheme of arc protection relay.
If anyone would like to know or practice for FEWA papers contact me on mohamedrashad2@hotmail.com Just completed the supervisor exam in April 2021
