Interested to Buy Any Domain ? << Click Here >> for more details...
what is difference between hart signal and analog signal (4 to 20 ma)
- 2 Answers
- 6051 Views
- Takreer, I also Faced
- E-Mail Answers
Answer Posted / asif
This enables two-way field communication to take place and makes it possible for additional information beyond just the normal process variable to be communicated to/from a smart field instrument. The HART Protocol communicates at 1200 bps without interrupting the 4-20mA signal and allows a host application (master) to get two or more digital updates per second from a smart field device. As the digital FSK signal is phase continuous, there is no interference with the 4-20mA signal.
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
what is a good line as ic engineer as maintenance ,oc, project, calibration ,validation engineer?
how to design orifice plate?what is the equation?
why use 50% lel methane gas concentration for gas detector calibration instead of 60% lel gas concentration whereas the hi alarm set at 60% lel.
How to calibrate level transmitter with use of HART?
Where are oxygen analysers installed in cfbc boilers? What are their usual readings?
In control valve proximity inductive sensor is taken as digital feedback for full open and full close.Normally its volts 24v when the sensor acts the feed back voltage 14v so that our relay not indicating in plc panel . kindly give the solution.
What is three element drum level control system why its better than single element?
Why mmwc unit is used?
1. For Steam drum level signal, why do we compensate with drum pressure signal? 2.For main steam Flow signal is comensated with main steam temperature signal and main steam pressure signal why?
what can of fault ofently come in vibration mesurement?
How we connect a instrument with ground, Give brief explanation with help of diagram?
What is the PLC configuration in Cement industry?
need to calculate flow rate with the help of dp range and orifice bore dia and size. range is 0 to 400 inwc and orifice size is 12 inch 150 # rf and bore dia is 7.180 inch. need to calculation for flow rate
Which type of diaphragm use in costic line, dm water line, natural gas line, oil line?
what is temperature compensation?
