how can change 10mm dia @130c/c bar spacing to 8mm dia
- 5 Answers
- 42417 Views
- TATA, I also Faced
- E-Mail Answers
Answer Posted / rajesh kumar jha
spacing = ast/Ast
130 = 8*8 / Ast
Ast =64 / 130
Ast = 0.492 then after
spacing = ast / Ast
= 10*10 /0.4925
= 203
spacing = 200
ASt = area of steel
ast = area of bar
| Is This Answer Correct ? | 16 Yes | 16 No |
Post New Answer View All Answers
How we can calculate the cement, sand,bricks , water , quintity in 1:6 Ratio 1 cubic metre b/w and 1:4 Ratio in 1 Squre metre b/w????
If we have the center line of the Finnish road level and we want to know what level of pay would have offset the Lhs and Rhus RHS 1,2.5,5 1,2.5,5 m.
What are the basic use of runners and standards of pipelines?
Explain the benefits of using standard terminology in the measurement process?(Tendering and estimation)
What is Critical path in Ms-Project ?
Exterior Joints,define
Which is the indian standard code of line out. ? How much tolerance fot 1 mt lenght? Its challenge....
any book or article on pumped concrete.
What is M40 _ TOR - EQ and B.F.S
Define angular dimension?
how can we construct building without foundation providing only grade beam at ground level
Sir, Iam Applied in rrb for the posts of Junior Engineer.I want to know about the or question previews to study well.Pl send it to shukla_varun1985@yahoo.com.
what pressure the NP2 class RCC pipe can sustain?
How much 1 cum of M15, M20 & M25 concrete weigh?
how to find out hard strata in bored pile when the DMC method adopted.
