Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / rishikesh borse
Holding current is always less than latching current
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Why you are switching off arc protection mcb when you are taking shutdown for lv board.
From past few months I am getting lagging pf even though sufficient capacitors used in circuit. Where is the problem pls answer
11kv/433v delta/star distribution transformer primary side full load Ht current is 83.33A in , but input side VCB rating 800A.why?
How we calculat the NGR of 3phase Generator, Our generation voltage 11KV
what is meant by power and distribution transformer ?
importance of reactive power management
explain comutator action in detail.thanks
Why the dc voltage drop during starting of emergency lube oil pump? The Voltage drop from 135kv to 125 kv for one min. before re-establish to 135kv?
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
What are the uses of stepper motor?
what is meant by impedance & transient protection?
What is the difference between the impedance percent and impedance voltage ?
1. If 8.35%Z means the percentage impedance of 132kV-line from power company, we will like to confirm its base capacity?
Why water bubbles when D.C. Current is passed through it? Why not when A.C. Current is passed?
Give details on how you intend to handle a challenging position you are posted to manage unexpectedly as a company staff?
