Answer Posted / s.kalpana archana
Instrumentation is about measuring,controlling and processing the various parameters such as pressure,temperature,flow,level,etc.....
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
what is use of communication wire in multipare cable(oil and gas field), why this communication wire not used in single pair cable?
how to calibrate Necleuonic level transmitter.?
Specify ideal accuracy of flow element like orifice plate, Ventury, Annubar. Ultrasonic flow meter etc.
Turbidity analyzer working principle ?
PT RTD Range: -200 to 500 degree celsius If I configured in DCS Lower range and Upper range . In face plate it shows red colour due to overa range how was the characteristics look If the temperature is more than operating range. how was the characteristics look . whether its in Resistance vs Temperature curve is Linear or Non linear
can any one tell me when ongc placement test and its forms is available????/ pls tell me if u know
Give an example where you had aproblem on the job, and tell me how you solved the problem. and the finalvoutcome.
How can i copy program (parameter) from mm440 (V.F.D.) by using BOP?
Explain operation of Haskel pump.
diff between neutral ,ground,phase , earthing and shielding?
how to do dynolab wind speed sensor loop test, how to simulate value,i have simulate mA 4-20mA but not responding in DCS faceplate, please kindly advice me any one.
What are the type of bonnets in the control valves?
what is the procedure of belt scale calibration?
Name different parts of a pressure gauge.
the pump holds on run indication into the dcs and filed local control panel remote push button condition operaton wrong like when the push button pushing conditions the pump is off and the push button release condition the pump is on totally opposite condition . And control room inside give the stop command into dcs just 1secon relay engage and again normal condition. How can I slove
