Interested to Buy Any Domain ? << Click Here >> for more details...
what is inverter and converter
- 7 Answers
- 7159 Views
- Shrishti Power Technologies, I also Faced
- E-Mail Answers
Answer Posted / kamalesh
inverter is a device in which current flows from load to source. it is mainly used to store and discharge the current when necessary
convertor is a device which convert the current or voltage from one form to another or viceversa
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
HOW TO CALCULATE THE HEAT AND LOAD OF LT-SUBSTATION WHICH CONTAINS 2*1MVA TRANSFORMERS,LT-SWITCH BOARD,MLDB,ACB,BUSBAR,ETC,......?
For refrigerators the motor current is raised beyond its rating on both conditions when the voltage of the system is more(say 270v) than the rated voltage(220v) as well as when the voltage of system is less(say 160v) than normal voltageof 220v, why explain?
What is the typical enclosure type used for Indoor switchgear / Outdoor switchgear Units? - In Onshore / offshore Units?
66kv under ground cable how to layaing in ground any special case two ckt r runing
why do we need to use 3c+3e cable, normally i select only 3c+e cable and i think it is enough. pls explain the usefull of 3e cable ( in this project the earthing system is well done)
Why neutral cable carry current.
in wind mill use 2100 kw asychronous generator ( induction generator ) rotor voltage : 3300,stator voltage : 690, rpm : 1511 type : MRL063E04 ' we check rotor resistance magger value found following. R-EARTH - 00 M.OHM,Y-EARTH-34 M.OHM,B-EARTH- 33M.OHM R-Y: 31 M.OHM, Y-B: 00 M.OHM,B-R :33 M.OHM HOW CAN I TAKE DECISION?pls ans. quickly
I have doubt that the supply HZ (very low or high than rated ) may affect the power factor. is it true. ?
how to calculate the Neutral transformer impedance?
i want design of D.C.MOTOR 1HP 960RPM AND 2HP 960RPM ITS URRGENT
Can Anyone suggest the Standards (IEC or IS) for selecting copper current density?
What is the difference between the impedance percent and impedance voltage ?
what kelvin's law ?
what is the difference between megger and earth resister ??
Control cables in S's will carry 1000v which is AC R DC? Pls answer me
