A 60w bulb & a room heater are connected in series.if 60 w
bulb is replaced by 100w then what will be the effect on
heater out & why?
- 6 Answers
- 14731 Views
- I also Faced
- E-Mail Answers
Answer Posted / habeebj
The resistance for 60W bulb is more than that of 100W bulb. Therefore voltage drop is more in 60W bulb. Due to the voltage drop the heater output will decrease.
| Is This Answer Correct ? | 7 Yes | 10 No |
Post New Answer View All Answers
What should be the amps for a MV fuses for transformer 630kVA 20(10)/0.4 kV
1)we have 1000 cfm Blower,Dia-1Mtr,Velocity of air 94 m/s 2)We have Natural Air velocity 94m/s 3If i Put Wind Mill in natural air ,speed is 94m/s Then it will generate Assume 100kw 4)If i put same wind mill across the Blower,air speed is same 94m/s now the Question is Will it generate 100 kw?
why high speed tripping relay will be used in tripping circuit why not normal relay
i had aplied Hindustan Petroleum corporation limited for the post of maintenance technician -Electrical,i want model questions,if anybody have please send it or please advice?
If we need4× 50mm sq cable but it's not available so we can pull 4×25mm sq 2cables
If I want to lift the water at a height 50m from ground level through two inch(diameter) metal pipe then what is the capacity of motor pump is required? is it possible in single phase supply or not?
How is the gain affected by the introduction of feedback in a control system.
sir my exam is on 19/6/2013 under electrical branch pls send me sample aptitude questions as well as sample technical questions for jindal steel and power company
what is laser diodes?
give some advantages and disadvantages of combiniing the session, presentation, and application layer in the osi model into one single application layer in the internet model
What is the difference between vector surge relay (78) and Pole slip relay (98G)
Show the schematic arrangement of diesel power station layout and give its principle of operation.
in basic 2 phase will short means tripping the power but spot welding 2 phase shorting but not tripping it will welded why.....(Q)
Sir 33kva 2 transformer load 900 amp calc 1800 amp mana jayega
Hi Everyone ! My Name is Hakim ullah khan please i need formula of Cable Rating because i want to calculate by self without check any Table Chart... Thank you.....
