Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / sureshkitech
first you workout orginal quantity in mesurement, secondly workout in masonry. what is the diffrence between brick in measurement &brick in masonrybrick in masonry is less than brick in measurement.that means less the quantitry of cement mix. calculate howmuch percentage is the cement sand mix. less from the measuement quantity. then you will get how much quantities of bricks per m3. o.k
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
How will you Engage Labours on Site?
in a corner footing of a building, column lies in one corner. in this condition i want to know if the reactive pressure of soil will be uniformly distributed throughout the footing or will be uniformly varying as in the case of eccentrical loading.
What is the outturn of Ceiling plastering
I have an plot with area 35*47 = 182.77 sq yards. Out of this iam planning to construct house with 1350 sqfeet each floor .iwanted to build a G+2 house.Need cost estimation for each item
how many sqft or cft of work done by a mason per day in all works such as brick,block,concrete,shuttering carpenter,reinforcement fabricator,painter,door window carpenter.....everything thank you
What black man invented the clothes dryer?
at which depth the construction of tunnel is economical from cost and engineering aspect.
In an aggregate blending plant, water is sprayed before blending is performed. If the fine content in aggregate is as high as 25 %, will not the fines form into lumps / balls and distribution will not be uniform ? Further, the fines will stick onto the interior of pug mill and its content will be low. The mixed material is stockpiled for weeks / months before use. Will it not be better that blending is done in dry condition, and water will be added only during compaction at site. Please forward your comments and suggestions.
Minimum concrete cover in slabs, columns, beams, foundation and other st?
What is high adherence steel bar? I have a general specification which refers to High Adherence steel bars, coils and meshes to BS EN 10080 and BS 4449 or BS 4483. Is this just general re-bar or is there something different about it? The spec originated in France.
how much quantity of 1.5" nails and 2.5" nails are required for conventional formwork shuttering?
how to find out hard strata in bored pile when the DMC method adopted.
how to find ssm in foundation?
how will remove spiderweb cracking in plaster ? what the reasone of make it ?
How to calculate chejja reinforcement
