Answer Posted / m.arun kumar
Because of excess of wire in the system....
Is This Answer Correct ? | 0 Yes | 3 No |
Post New Answer View All Answers
What are your future plans for the company if permanently employed?
As an electrical engineer what are the responsibilities which i can hold in TCS?
What is inrush current?
In single phase ac ups supply when current is measured with tong tester neutral current is found more than phase current.What is the reason?
what is the principle of the single phase energy meter? and,what is the advantages and disadvantages of single phase energy meter?
What are the factor to be consider for CT selection in 132kV substation?
State ohm’s law?
I am using submission of two ct in one and half scheme for 67/67N protection. Both CTs star point is grounded separately near ct box.Will two point ground give wrong tripping to 67/67N during fault or no matter.
Can we use Ccapacitive voltage transformer directly for metering purpose?
how to determine the inrush current of a transformer
please send me latest & previous years question papers for IOCL Technical level questions
during installation time of transformer and alternator which points we have to observed?
how to get bearing & winding temperature of an induction motor?
what is relation between ct and pt ratio with multiplication factor of a energy meter? is there any other factor on which multification factor depend?
What is the IS standard for MCCB to be use (As per capacity of AMP)& for ACB also.