Interested to Buy Any Domain ? << Click Here >> for more details...
how to check the continuity of a cable with a megger
- 4 Answers
- 5634 Views
- Metro, I also Faced
- E-Mail Answers
Answer Posted / dasharath waghmode
To check the continuity of a cable, first short any two cores of a cable at one end and test same cores for continuity on other end by megger. If both cores are open it will show high resistance and if not will show zero resistance. And repeat the same process for other cores.
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
What are the advantages of the three-phase motor over single phase motor?
What are reasond for high wattage in single phase induction motors
am commissioning the trafo without connecting the neutral therefore unbalance will occur what is the alternative solution for this?
how to calculate the settings for shaft ct protn in hydro generators
how the phase convertor changes the no. of phases
How to calculate MCB Breaking capacity.
Igfet is a
what is the difference between b c d curves on mcb
Why the power factor improvement is so important in industrial loads
what will happen if i connect 12 volt battery with 24 volt battery charger.
hello if any one have papers vof hpcl or sail, plz send me
Transformer diagram mention each parts ?
how hydrogen cooled alternator undergo maintanence ? that is hydrogen when come in contact with air can result into explosions .
In case of HV test on medium voltage cables, BS is asking for 4 U0 where as IEC is asking for 3.5 U0. Can any one advise me how this 3.5 times or 4 times U0 is derived?
how to find number of run cable laying[LT side] for transformer & alternator secondary side? [above condition for getting output power transformer to main panel side] give the example.
