i have ht transformer of 142 kva with air cooled facility,having secondary voltage 7850volt, and secondary connected full way bridge rectifier .i faced the problem repeatedly that transformer one coil and rectifier diode of two phase was burnt two times. i checked all the secondary ckt. no any short ckt found,then what will be the cause side
Answer Posted / arun
The current rating of diode may be low and the failure of diode might had had effected the winding of transformer.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Why water bubbles when D.C. Current is passed through it? Why not when A.C. Current is passed?
Why use in ht motore
CAN ANYBODY PLEASE TELL ME HOW TO DESIGN A SERIES REACTOR FOR LIMITING SHORT CIRCUIT FAULT CURRENT??
What range of speed can you get with the field control method of speed control of d.c. Shunt motor?
If oil and air can withstand a high MeV when used as an insulator in a transformer, what are the values of how high for each material?
Define end float in a motor?
what is negative d.c. voltage, why this voltage is used in base transciever station.
is this the formula of building wiring to get the main breaker.Watts/volts*.8%+higher motor*(25%)=ampere. yes or no or send the correct formula for building wiring.
What is the purpose of stablization resistor in high impedance bus bar protection
High voltage test procedure of in swgr board. why should measure millivolt drop on testing time?
we have a lot of model of rectifier but thyristor rectifier is the most rectifier that use in power system. Do you know why this rectifier is used?
what is RNG in the DG synchronizing by PLC?
Advantage of LT panel vs HT panel
How can we measure the residual voltage in dc machines?
draw a circuit diagram connecting transformer OLTC- RTCC- VCB-Marshalling Box otherwise Explain in words