i have ht transformer of 142 kva with air cooled facility,having secondary voltage 7850volt, and secondary connected full way bridge rectifier .i faced the problem repeatedly that transformer one coil and rectifier diode of two phase was burnt two times. i checked all the secondary ckt. no any short ckt found,then what will be the cause side
Answer Posted / sanjayjssate
First open all the cables and take megger of all cables , there must be some earthed cable which is causing this problem.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
What is primary and backup protection?
Is there any type of starter for DC motor other than two point,Three point and Four point starters?
How do i carry out or know the vector group of a Dyn1 and Dyn5 transformer
Why synchorised generators are used for the production of electricity?
what is the usage of microcontroller in the panel board?
what is the ms flat constant for calculating earth mat design calculation?
if any body have question paper of railway (section engineering),then plz send me .i will thank of him/her.
Explain the advantages and disadvantages of thermal power plant?
why induction motors are rated at 0.8 power factor.
why fractional pitch winding generally used in alternators?
plz send me HPCL apptitude paper.. maulik_elect@yahoo.co.in
it is in our knowledge tht right plug of supply of residential suppy system is phase n other is neutral...howevr the battery charger of mobile works in both ways...i mean it is not restricted in only one direction.ny of the holder of charger can hav phase .so y is it not lik tht phase of supply must b connected 2 phase of charger...?
What is meant by control system?
could you measure current in parallel?
How is the percentage impedence of a transformer fixed at design stage???