Interested to Buy Any Domain ? << Click Here >> for more details...
how can we avoid magnetostriction in transformer?describe
the suitable methods.
- 3 Answers
- 7937 Views
- Bhel, I also Faced
- E-Mail Answers
Answer Posted / dilip kumar
Magnetostriction is the effect due to non uniform arrangement domain or grain in the core material.
when alternating current is passed through the core having non uniform grain arrangement, then for every positive and negative cycle the transformer core tries to expand and contract (100 times/sec for 50Hz transformer), due to which some fast vibrations are produced on the transformer,which inturn produces a humming noise in the transformer), it cannot be avoided.
Magnetostriction can be minimized by using the cores which have more uniform grain orientation. (eg:CRGO)
TO totally avoid the Magnetostriction effect, one should go for DC instead of AC (where you can't say that as a transformer anymore).
HOPE IT HELPS!!!
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
how to put cable sizing and cable glands size for respective cable & Cable Lug size in a DB sectors???
The synchronous machine excitation system explain
What is meant by earthhing of a magnetic flow meter and when to use empty pipe detection?
What test must you do before powering up a circuit that you have been working on?
WHY THE COLOR OF OUTDOOR TRANSFORMER IS BLUE ONLY???
how to calculte capacitor range for single phase induction motors??pls tel
What is servo motor? what is its purpose?
what is the purpose of slope in the differential relay?why we are using two slope?but in busbar differential we are using only one slope.why?
How can I model an open-delta ground transformer for a network supplied by 4 unit GTG and power transformer in ETAP?
What is different between Circuit breaker and Isolater?
What is the angle of inclination for the oil connection from transformer conservator to Bucholz relay and why?
which connection is safer series or parallel?usually which connection we prefer at home?
what would happen if reactive power (kvar)is increased (more)or decreased (less)? how much exact reactive power should be maintained? and what should be done for that
How does the phase sequence controller works, how it identifies the phases? confirm working principle
am commissioning the trafo without connecting the neutral therefore unbalance will occur what is the alternative solution for this?
