Interested to Buy Any Domain ? << Click Here >> for more details...
what is the difference between id fans and fd
fans
- 12 Answers
- 157976 Views
- Perkins Thermal Systems, I also Faced
- E-Mail Answers
Answer Posted / virender kumar
ID fan(Induced Draft Fan)basically pulls out flue gas from
the furnace of boiler. It is located between dust
precipitators(ESPs) and Chimney. Obviously it handles hot
air/dust. Whereas, FD fan(Forced Draft Fan)supplies the
required air into the furnace for combustion of fuel. It
handles air at normal temperature. The capacity/power
rating of ID fan will be more than that of FD fan
| Is This Answer Correct ? | 12 Yes | 2 No |
Post New Answer View All Answers
what is the use of the puls transformer in UPS & how it works???????????
which stabilizer is better ? AVR, Servo Stabilizer, Static stabilizer etc & why explain it
A 2083kva AVR was tested, phase to ground shows continuity, what is the implications
what is meant by motor startup supervision & motor load jam protection ?
what happen if the load connected to the induction motor is taken away? the same question for synchoronous generator in synch i think that the the exitation voltage will appear on the terminal only if so plz answer me
Why do not we prefer non conventional sources of energy to conventional sources?
In Dyn11 power transformer if any one of the 3 phases connected to earth in star connected side then please explain effect of the current flow in delta connected side of transformer.(In this case if one phase is shorted to ground in star connected side then we observe the current flow in two phases only not three phases in delta connected primary side. Please explain why it is so?)
can we choose current transformer secondary, to calculate residual flux in a power transformer, so as its saturation is close to the saturation level of power transformer?
what is the use of power transformer in GSS.
what is strip power factor?
Is there a possibility to use such a treshold voltage for the NMOS part of a CMOS circuit that during the switching it will start conducting only after the PMOS part will be already closed, by this eliminating the leakedge current? Please note, I'm not asking about the well bias in standby mode, but about the "antileakedge" measures during normal operation.
Circuit diagram of tube light without starter using electrical choke
What is the problem of internal failure in ship engine telegraph system norcontrol?
how can maintain the power factor and why and this is how do work tell us
What is the tension required for the 25000 CFM AHU belt
