Interested to Buy Any Domain ? << Click Here >> for more details...
A differential pressure transmitter is configured to measure the height of an open tank : height 10m and dia 5m.
Suppose this same transmitter is shifted to another open tank : height 10m and dia 4m.
What will be the %error in measurement? how?
- 3 Answers
- 4699 Views
- McCoy Engineering, I also Faced
- E-Mail Answers
Answer Posted / sundara_k
no error because of both tank is open and height same
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
can we replace a slot sensor (inductive type) with limit switch (potenial free contact / no-nc type).
what are the selections available in configuring a burnout protection of a controller? thanks
Explain the difference between mmwc and mmwg?
In control valve proximity inductive sensor is taken as digital feedback for full open and full close.Normally its volts 24v when the sensor acts the feed back voltage 14v so that our relay not indicating in plc panel . kindly give the solution.
Why plc require in analog input 4-20amp & 0-10 volt?
Why does a pressure gauge installed on reactor, doesn't have any vent line below to release the pressure? Is it any kind of designing mistake or it actually does not require any vent line? And if it does not require any vent line below it then how we are gonna release the pressure built inside the pressure gauge?
What is the difference bitween control net scaner and device net scaner
what is the process for double acting cylinder pneumatic for 32' v/v
how to calculate range of level transmitter?
Calibration procedure for Electro magnetic Flow meter
State four different types of flow measurement, for gas flow measurement MMSCFD is the common unit expand the unit and specify significance of word S in the unit.
What are different types of control valves?
With N nodes and B branches what will have a network ???
How to do gas analysers calibration in AUTO and Manually by using zero and span gas?
What are the types of valves?
