Interested to Buy Any Domain ? << Click Here >> for more details...
What is the lap length for tension members if you have 16 dia steel bar and a concrete fc=30.9 and steel grade60 fy=414 mpa
- 4 Answers
- 7887 Views
- L&T, I also Faced
- E-Mail Answers
Answer Posted / meena garg
lap length in tension member 30d
so lap length is 480
| Is This Answer Correct ? | 1 Yes | 2 No |
Post New Answer View All Answers
how do i remedy a foundatiom that the column bases was cast and aftet 28days crushing the conprehensive strength of the concrete fall below the specification 25N/mm2
in one hour , one 200 excavator , how much quantity (mcube)can load ? soil is not hard not soft
in one SQM plaster how much Cement and sand consumed in ratio 1:4
What is the use of offset command?
TO CONSTRUCT A 1800 SQFT CAPACITY UNDERGROUND WATER TANK HOW MUCH CUFT CONCRETE IS REQUIRED AND HOW MUCH REINFORCEMENT IS REQUIRED. FOR COSTING
How to calculate(Thumb rule) the consumption of steel per cubic meter for different concrete members.
residential projects,structural.
in the earthquqke the profile of water on dam is parabolic or not
is there any thumb rule for calculating construction cost of the building with pile foundation per sft. area?
what is the 0 value in quantity surveying
what is right & short method of measurement of slab&beam
What is geopolymer based concrete?
What happens when,in Prestressed girder the HDPE duct and cone size is provided more than required? (technical answer expected)
Slab quantity
What distance in meters on the ground is the equivalent of one second of arc in longitude or latitude?
