How the unidirectional torque produced in dc motor
- 2 Answers
- 8551 Views
- CGL, Sail, I also Faced
- E-Mail Answers
Answer Posted / umesh
The torque formula for dc motor is T=k(current * flux)
The commutator with brush converts the dc into ac which produces alternating flux.It means both armature current and flux are positive or negative at the same time.
| Is This Answer Correct ? | 1 Yes | 2 No |
Post New Answer View All Answers
all interview questions with answers of ntpc (2000-2009
WHAT IS THE WINDING PROCEDURE OF ELECTRICAL MOTOR
please tell me how a surge protector work on a DC 48Volt.? please describe briefly.
Dear all, I just want to ask an expert on this forum for some insights. For the magnetic balance test, when applied voltage on a Delta-Star transformer e.g. Dyn11, the following relationships apply for HV side: 1. H1-H2 = H2-H3 H3-H1 2. H2-H3 = H3-H1 H1-H2 3. H3-H1 = H1-H2 H2-H3 For the LV side also: 4. X1-X0 = X2-X0 X3-X0 5. X2-X0 = X3-X0 X1-X0 6. X3-X0 = X1-X0 X2-X0 Is there a similar pattern for Y-d, Y-Y, D-d? And how about Y-z, D-z, Z-y transformers? I've tested a YNzn5 transformer and for LV side I don't see the pattern. In this particular case I got for LV side the following (see values below): H1-H0 H2-H0 H3-H0 X0-X1 X0-X2 X0-X3 128.0 119.9 7.2 29.2 13.3 15.8 70.7 128.4 59.2 23.4 22.0 3.6 7.2 120.1 128.1 13.4 29.3 15.8 What is the relationship here for LV? For row 1 I see the relationship, for row 3 I also see but it's shifted, but for row 2 I don't see such relationship. Any suggestions, answers, someone?
For group 1 , 2 whather i have to prepare my technical or general studies etc? and im graduate in ee engg. for wht posts im eligible for? please tell me!
Where servomechanism is used?
how can maintaince the acb contactor moveing and fixing kit
errection check list for transformer maintenance
Thermal withstand capability under full short circuit conditions, in terms of number of times of occurrence of short circuit and corresponding anticipated percentage reduction in transformer life.
SIR, GIVE ME OPGW SAG CALCULATION FORMULA I AM DAE ELECTRICAL. THANKS
The electrical energy required to raise the tempreture of a given amount water is 200 kwh. If the heat losses are 20%, the energy required is?
In a voltage-controlled current source A A current booster is never used B The load is always floated C A stiff current source drives the load D The load current equals Isc
For small size, high frequency coils, the most common core material is- a. )Air b. )Ferrite c.) Powdered ion d.) Steel
1. How many types of mangers? 2.How many types of capacitors? 3.pls tell me normally types alternator problems?
what is the chiller and working principal
