Interested to Buy Any Domain ? << Click Here >> for more details...
A 60w bulb & a room heater are connected in series.if 60 w
bulb is replaced by 100w then what will be the effect on
heater out & why?
- 6 Answers
- 16844 Views
- I also Faced
- E-Mail Answers
Answer Posted / maayu
the series circuit 100watt bulb are low resistance. so current will be in-cress that was the bulb make more heat
but the KWH is discress
| Is This Answer Correct ? | 1 Yes | 3 No |
Post New Answer View All Answers
1. What is the exact formula for one weber? for example,(one ampere = one coulomb electron of electrons crossing a point of conductor at one second. i.e, 1A=1Q/1sec)
from which formula we select a capacitor rating?
Describe the control mechanism of missile launcher???
What is kvar?
How do i carry out or know the vector group of a Dyn1 and Dyn5 transformer
In single phase capacitor motor, if the motor rotate reverse direction then how much power will be consumed by the motor and why?
What is the maximum percentage voltage drop (vd%)for a motor control center
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
i have a 4 Mva transformer 34.5 kv / 480-277 v and i used 2 parallel 3200 amp bus duct for the secondary feeder using 3 ply of bus bar ( 3/8" x 5" ) as a common where the flexible link terminated and 6300 amps breaker for the main, the lower bus duct reaches 70 degrees and the upper bus duct reaches 55 degrees when i used thermal scanner. why the temperature is not balance when the load reaches 3600 amps.
If I want to replace a 26KW Slip ring Motor with a Squirrel Cage motor & Drive (for a Hoist Application). How can I approximate the Motor & Drive HP required in new Setup.
Why open circuit test of transformers is conducted at rated voltage??Why not any other voltage??
at meter room 50 hrc switch installed,but there are not get earthing proper,so what happen?and 11kv transformer out put going in to hrc main 400a three nog each? so earthing is require for all switch? (some customer made earthing at there home.)
how to calculate insulation level of transformer?
why wire sizes are 3/29 or 7/29 and why not wire sizes are 2/29 or 6/29?
how we can calculate the efficiency of a diesel generator ?
