Interested to Buy Any Domain ? << Click Here >> for more details...
What is the meaning, function and application of OLTC?
- 3 Answers
- 5747 Views
- Home, I also Faced
- E-Mail Answers
Answer Posted / tarun pradhania
OLTC - open load tap changer
OLTC is used in transformers for voltage level step up or step down.
| Is This Answer Correct ? | 2 Yes | 5 No |
Post New Answer View All Answers
Why we make earth connection with Transformer Body and What will be the minimum size of copper wire as per code with respect to KVA rating of Transformer?
what is effect of length of air gap on performance of dc motor and generator?
Why does the rotor rotate?
how to find 5 kilo meter long under ground 33 kv cable fault location if IR VALUE shows 0.05 M ohm @5000 volt.and cable fault locator shows some time fault distance 3 kilo meter ,3.7 kilo meter and some time 1 kilo meter? now how to find the fault location that where is leakage. note--it is tested with 5000 kv megger and insulation resistance is 0.05 M ohm. and some time 0.03 M ohm comes.
Define cut-off rate?
What are :- AC Distribution Board (Single & Double Front) DC Distribution Boards Distribution Board LT Breaker Panel.
What is the practical way to calculate the cable size for known ampere load?
advantage of motor design on higher power factor . normally motors are designed for .8 power factor. what is advantage of designing at .88 power factor
When color of silica gel will gets change from blue to pink from Top to bottom?
what will be happen if earth point is being used for as a neutral point for raw power , and same will be used for ups earthing
What are the basic components of the feedback control system?
A 100KVA SINGLE PHASE TRANSFORMER 10000/200V,50HZ REQUIRES 300V AT HV SIDE TO CIRCULATE FULL LOAD CURRENT WITH LV SHORT CIRCUITED.THE INTAKE IS 1000W.THE % OF REGULATION ON FULL LOAD AT 0.8 PF LAGGING WILL BE HOW MUCH AND THE SECONDARY TERMINAL VOLTAGE ON 0.8 PF LEADING WILL BE
what is the calculation involved to design the heater to heat 10KL of water in temperature control unit?
Why collecting electrode of ESP to be earthed
delta motor winding resistance I take normally single winding is 2.5, which value is came delta connection ie RY ?
