Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / azad
The Main difference between PLC and DCS is SCAN CYCLE. PLC can able execute the instructions as one by one. whether DCS can make it as a page by page. So scanning time is reduced in DCS compare to PLCs.
Simply, If you have up to 10K I/O's you can go for PLC.
If You have more than that choose DCS.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Which is the best field foundation bus. ( FF ) Yokogawa, Honeywell or others ?
how can i check vortex shedder bar it is ok? if there is ohms condition are shown correct?
Why ac supply load cell is used? Can we use the dc supply load cell?
What is the use of each wire in three wire RTD
-/5A. What is the meaning and limitations of this in energy meter constant. It is a 3 phase LT Energy Meter. If this Energy Meter is connected through a CT of ratio 200/5 Amps, then what is the multiplying constant and how its will be calculated.
where cascade loop use ?
what is the calibration procedure for transweigh make weigh feeder?
i am preparing for BARC ,so plz mail me how to prepare for BARC. ALSO IF POSIBLE SOME RELATED QUESTIONS. MY MAIL ID IS khushi_4uall2003@yahoo.co.in
Draw symbols of the following :
What are the type of bonnets in the control valves?
hi! i want to know about mpse exam.
How many interlocks at turbine? Plz explain briefly
what is output of FOUNDATION FIELD BUS transmitter
What is rang ability?
State four different types of flow measurement, for gas flow measurement MMSCFD is the common unit expand the unit and specify significance of word S in the unit.
