What will be the angle for hook in column ring for column size 600x750 mm bar size 10mm for ring
Answer Posted / manjit singh
135 DEGREE
Is This Answer Correct ? | 7 Yes | 0 No |
Post New Answer View All Answers
For plate load test why we are applying pressure 3 times the proposed allowable bearing pressure? Is there any supporting standards for this?
HDPE pipe standard bends using for TSE irrigation? is it possible to use 30 degree?
in one hour , one 200 excavator , how much quantity (mcube)can load ? soil is not hard not soft
how to find out hard strata in bored pile when the DMC method adopted.
what is smart building materials?
what is the most suitable foundation when construct a bird watching tower in a marshy land
Rate analysis for construction of a solid block masonary of size 400x200x200 in C.M.1:5 in superstructure .Compressive strength 5.00 N/Sq.mm Confirming to IS: 12894:1990, with necessary scaffolding, raking of joints and pointing the same. I require rate per Cum.
what is the use of beam end forces while using a staad ? wha they are show
What is dead load impact load live load
I need to constructive work in amaraj batteries
What is the veriplus for ellips card length formula (major axis 3.4m,minar axis 2.6m spacing 0.2m
What is Density of cement, sand & aggregate ?
What are the different methods for drawing an arc?
For elevated service Reservoirs what will be the output of each skilled carpenter and bar bender.
while doing the structural works of a simple ground+1 villa, can the columns be continued immediately after neck columns without tie beam, while the tie beam to be done after columns concreting.