Answer Posted / ananth9738
Common weld defects include:
• i. Lack of fusion
• ii. Lack of penetration or excess penetration
• iii. Porosity
• iv. Inclusions
• v. Cracking
• vi. Undercut
• vii. Lamellar tearing
| Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
what will be the min curvature ratio for Round Bar dia. 1” size in material grade AISI 4330, Yield strength 115KSI Tensile 140KSI?
Name two types of leak detectors and the method of application for each?
What are the causes of low compression in the main engine?
Difference ISDN and Brodband?
How can check gear pitch?
Explain the difference between blower and fan?
Explain the difference between an electric motor and an electric generator?
send me tech quesions please to 470.rajesh@gmail.com
Wasco Interview 1-the type of transducer that convert mechanical movement into a voltage 2-pump 2500 psi and 100 MG select it 3-modes of heat transfer 4-the difference bet PSIA and PSIG 5-the function of relief valve and no return valve (check valve ) 6-types of bearing general catogires 7-function of bearing 8-compressor surge 9-pump cavitation 10-define critical speed 11-compression ratio decease volumetric ratio ........... 12-using inter-cooling in multi stage compressors to ....... 13-using cascade system in refrigerator function ? 14-define performance and efficiency .
What is the use of multi tester?
different between general arc welding & aluminium welding?
What are the causes of damage to propellers?
what is the reson in a/c system that TPN TRIPPING
please briefly explain the Discharge process and Formula of Centrifugal Pump
how to design a crankshaft?
