Interested to Buy Any Domain ? << Click Here >> for more details...
what is meaning volt-hz ration,where is necessry tomaintain
and why. specialy during increase the power of generator.
- 3 Answers
- 5850 Views
- I also Faced
- E-Mail Answers
Answer Posted / gbs
V/f determine the overfluxing condition..
normally its used for over excitation condition in generator protion. if v/f increases core will saturate.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
i have to install a HT panel, what components, I have to use in this and what will the diagram of that diagram,please tell me each and everything.
in non technical way how can u define POWER FACTOR??
how can see the ac indoor or out door ac which Tr
full form of electrical?
As we use capacitior bank in 3ph ckt for improvement of PF, why not we use capacitor in single phase domestric use, at our house their are many inductive equipments,like fan,mixer,tube choke,air conditioner they also draw PF... by using capacitor can they improve PF. if yes--what are advantage and how to connect a capactor in single ph,and which type of capacitor if no- what are disadvantages.
IF alternator SCR value will be high means what happen in alternator efficency at operating power factor of 0.8
A motor running with lenze frequiency inverter stops if I REDUCE SPEED with 25% load.If I run it in High speed and medium speed running smoothly with full load.please help me to solve it.
Transformer cores are laminated in order to A simplify its construction B minimize eddy current loss C reduce cost D reduce hysterisis loss
What is difference between YNyn0 and YNyn ??
Whether it is possible to measure energy at the input of rectifier transformer (12 pulse with very high odd harmonics)
I completed my BE EEE degree 2006 .... which license should i apply .... ?????
Why should be the frequency 50 hz 60hz only why not others like 45, 95 56 or anything , why should we maintain the frequency constant if so why it is only 50 hz 60hz?
what is arc flash and what are the hazards involved
In case of HV test on medium voltage cables, BS is asking for 4 U0 where as IEC is asking for 3.5 U0. Can any one advise me how this 3.5 times or 4 times U0 is derived?
Single phase and threephase power calculation
