Why we are mention U1, V1, and W1 in primary side of transformer give technical reason
Answer Posted / ashish kumar tripathi
For parallel operation of transformer to take same polarity.
| Is This Answer Correct ? | 5 Yes | 2 No |
Post New Answer View All Answers
what is physical distance of isolator to VCB in 33/11kv sub stations
Is it required to lay GI wires along with GI/MS conduits from one point to another point though separate earthing cable is conncted from DB to Socket?
I want to make street light with solar system ... What may I do for procedure and how much of estimation for each material ... If any one knows guide me and inform this id : aravindd7@gmail.com
Why we are using only Dyn11 tranformer in distribution system but not using a Dyn1 in distributing system?why not and advantage and disadvantage in both
what is the thumb rule for determination resistance of resistor?
What is diversity factor in electric installations?
What is the transfer function?
how to find the torque of the single phase synchronous motor by doing an experiment
Can you please explain creepage distance in detail, for a 6.6kV cable head what must the distance be and how do you determine it?
how oltc works in rectiformers of higher rating (27 mva,200v dc,120kamps) please provide me full information with diaggram.
what is load vs Torque curve & why it is used?
Where can i get practical knowledge of solar system?
when we design electrical schemes of 11/.415kv distribution..wen and were should we show the relays??what is the function of it?for example..we place EFR Relay CT between transformer neutral link and transformer earth.Like this what are the other type of relays we should use?why?where?Explain please..Thank you
What is the importance of earthing?
We have 5 Distribution sections with variable loads&We have 3 Gensets(500kva,380kva&250kva) our total load is between 400kva to 600kva. so how could we connect 3gensets.