Interested to Buy Any Domain ? << Click Here >> for more details...
How to find the range of DP cell Transmitter for measurement of level in closed vessel.
- 3 Answers
- 5000 Views
- Rosemount, I also Faced
- E-Mail Answers
Answer Posted / kutti
The closed vaseal level transmitter range is identify ulta upper hp ,down lp;(negative range )
The open vesal level transmitter range is upper lp,
down hp .(positive range).
| Is This Answer Correct ? | 1 Yes | 2 No |
Post New Answer View All Answers
Hi Friends i am going to write BARC written test by this month 20th (20-5-2008). So please if any body knows the details about this or having previous question papers pls mail me to kkumarei@gmail.com. For Suggestions give one message to 9962122264
How we calculate orifice plat size???
what would be the minimum flow rate that we can measure on rotameter..?
all types instrumentation questions want
I was working on calibrating turbidity transmitters endress+hauser at effluent polishing plant.We calibrated using NTU buffers.What happened is that when we immersed the sensor, everytime we raise and lower the sensor gradually, the reading will vary.my question is that is there any specifications on what is the required distance from the bottom of the container with buffer to the face of the sensor?Is it ok to install the sensor in a medium which has turbulence specially if bubbles are present?
which type inter lock use in petrochemical refinery,and oil & gas?
you must show the examples application and give at least 4 types of transducer/sensors that can minimize the failure during the manufacturing of the resistors.
Hi i m B.E. In elect. & comm. I m workin in bio mass plant from 6 mnths as inst. Engg. but now i m in dept. Of operation as shift engg...which is best operation or inst. 4 me? M confusd..plz help and reply me..
what will the sending unit in the fuel gauge utilizes?
key phaser where is use and work
If a warning lamp will operate with the ground circuit is bypassed with a jumper wire to ground, what should you check?
What are the types of valves?
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
Instrument QA/Qc what is the project quality plan?conduit inspection RFI. which documents attache with package?
How the warning lamp of a charging-system is activated ?
