I have transmitter of range -20 to -5 kpa.if it is possible to zero trim with atmospheric pressure,means HP and lp having no pressure...what will get after zero trim and it is the right way.....plz give me reply ....
- 3 Answers
- 3983 Views
- KOC, I also Faced
- E-Mail Answers
Answer Posted / narendra mishra
Yes u can do zero trimming. You might be familiar with zero and span.zero trimming means setting zero(lower range value) for transmitter. U will get -5kpa reading in transmitter.
| Is This Answer Correct ? | 5 Yes | 4 No |
Post New Answer View All Answers
why we are using magnet for calibration of gas detector?
hii my name is sujith...i am preparing for HPVL GET 2010... so ,,,pls help me by send any previous questions or material to my site.....(Msujith_12@in.com) thank q
steps for installing orifice plate?
my data card only does run in my mobile so how can change it that it run other mobile & computer and i can stor data in my data card
Galvanizing.
How to convert milliampares into flow??
How can you add value to this Industry if offered the job?
why micro controller 8051/52's clock frequency is internally divide by 12 ?? and why it is further divide by 32 in UART serial communication ??
what is the difference between attemperator and desuperheater ?
Can I route 110 VDC and 24 VDC in a same Duct for our Interposing relay cabinet? IF yes or NO Please provide me IEEE Std. for the same. Please i required it on Urgent basis, i need to design IRP Cabinets and we have MCC 110VDC and Our Coil side is 24VDC, Please help as soon as possible.
on interface level transmitter model(RTG3302-EMERSON) What is threshold valve how can we select correct threshold value T1,T2,T3,T4 When interface water & hydro carbon
what is the procedure for auto tune in masoneialn 12300 series displacer type transmitter?
What is modbus?
HOW TO CALCULATE ACCURACY OF AN INSTRUMENT. WHICH IS COMPITABLE FOR USE.
How will you calibrate PID controller? explain with example.
