Answer Posted / ashish
when a fluid is flowing in a pipe at a point pressure of fluid equal to or fall below to the vapour pressure than boiling start and vapour bubbles formed in the pipe.when bubbles moves in high pressure bubbles collapse and high pressure force genrated and pitting action take place on metallic surface.due to this pitting force cavities are formed on the surface and this phenomina called cavitation.
Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
Hello Friends I had my ONGC test today,but it was very bad.But I would give certain suggestions so that u may not face he problem which i had. Be thorough with Electrical Technology.Generators.motors stators etc.There are 5 questions on that. There were also good no.of questions from Hydraulic machine and Production technology. Then 3 from Strength of materials.And remember the dimensional quantities.
What will be expected the cut-off of J.E Mechanical exam of RRB on 19/12/2010 ?
why the reaction turbines are not exposed to atmosphere? and why the impulse turbines are exposed to?
In Turbine how the balence piston works and what is the direction of leak of steam flow.
What is a combination thrust and radial bearing?
What is the sensitive part of the liner
On which analysis is based the dulong’s formula for the heating value of fuel ?
What is the use of center punch?
RRB exam model questions pls forward.
what is the difference between type -a and type -b iron > The chemical compostion is given here under and also guide us the effect of Ni;Cr;Mo in the iron; name and use of these two types of iron Type a Type b %C :3.15 2.65 %Mn:0.41 0.52 %Si:1.72 1.60 %S :0.090 0.082 %P: 0.215 0.204 %Ni: 0.40 Traces %Cr : 0.49 Traces %Mo : Traces Traces
What is meant by transmissivity?
What are the defects in exhaust valve?
which type feect in generator and turbine in reverse power protection
What are the causes of L.O. high temperature?
Is there a high demand for mechanical engineers right now?