Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / anwar hussain
Becoz the hv has high voltage but low current so for low current we need thin wire
| Is This Answer Correct ? | 15 Yes | 2 No |
Post New Answer View All Answers
what is the effect of vector group while phase sequence of a generator changes,whether the vector group changes or not
A 230V dc shunt wound motor has an armature resistance of 0,15Ω.When operating on no load at 650 rev/min the armature current is 6A . The motor takes a full load current of 85A. Calculate the full load speed if the field flux is (i) maintained constant (ii)reduced by 0,03
What is the formula to find out two phase active & reactive power
What do you mean by the zone of protection?
What is use of starter and choke in tube light
how hazordious area is classified at an oil & gas plant and categorise suitable class of electric equipment in that area like induction motors, LCS, Lighting Fixtures Fluerescent/Flood lights Mercury& sodium lights, J.Bs, Power Cables etc
we use capister for power factor. when we use capaciter in dg circuit than defect dg. can we use capaciter bank for dg circuit
what is capacitor voltage transformer?? how it is different from potential transformer?
a)In a 3-phase 4-wire circuit, a circuit breaker is selected to protect the circuit whose highest fault level is 6.6 MVA. Determine the required minimum breaking capacity in kA. (Note: Covert 3-phase power in terms of kA to find answer.) b)Using the below, determine the required minimum making capacity in kA as a “peak value”. Rate breaking capacity (Icn) ka: Icn<= 1.5 Factor = 1.41 1.5
how to electrically make connection to ferroli GN2N?
how test transfomer(3 phase75kva) by megger
What is the disadventage of gland earthing(power cable) if any. ?
WHY THE DIMENSION OF TWO SAME RATED MACHINE IS DIFFERENT ?
As we know diode work on both negative and positive but converting ac into DC we have to given a/c from negative of diode or positive side.please give me answer.
ii) A shunt motor supplied at 230V, runs at 900 rpm when the current is 30A. The resistance of the armature is 0.4 ohms. Calculate the resistance required in series with the armature to reduce the speed to 600 rpm, assuming that the armature current is then 20A. [12]
