Interested to Buy Any Domain ? << Click Here >> for more details...
Dear sir,
How to calculate 3.5 core pvc aluminium armoured cable meter wise,give with best examples.... please help me in this regards....
- 1 Answers
- 2714 Views
- Modi Builders, I also Faced
- E-Mail Answers
Answer Posted / krishnakanth
Boss, for AL cable 1sqmm take nearly 1-1.5A current, if the conductor size goes on increases to a large extent then take it has 1A. But there's no large variations from meter to meter... Ex: 5m cable and 15m cable there is no loading current variation, it varying in long cables due to voltage drop..
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
what is the voltage rating of chiller unit sensors
what is the ground fault relay,which purpose it will be use,clearly tell me plz
why the check zone and main zone are used for Busbar Protn. scheem?
What would cause a 240v choke that should give 110v out on a 16w lamp to gradually increase to 160v?
Why the power factor improvement is so important in industrial loads
what are the accessories need to be added while doing estimation for the following: 1.MCCB 2.MCB 3.ACB
If we use 250A MCCB as a incomer in Control panel for a fault level of 50kA for one second ,assuming temperature rise from 85 Deg. to 100 Deg , Then what will be the Aluminium Bus-bar size for 250A MCCB? Explain in detail.
why chock were used in old tubelights but are not newest tubelights?
1.what is the difference between transformer differential and busbar differential.2)why we are using 2 slope for trafo diif and 1 slope for busbar diff.3)what is the purpose of metrosil and stabilizing resistor in high impedance relay circuit.4)how metrosil reduce the peak volage.5)what is the funtion of stabilizing resistor
In diesel generator how AVR get voltage to excitation. And basic diagram DG EXCITATION CIRCUIT.
excitation limit of an excitor
how can i change the rotation of the AC single phase induction motor and show me by diagram
What is the necessary condition for stability.
How delta connection in the primary of distribution transformer reduces harmonics?how delta connections reduces harmonics?Please answer me...Hope that question is correct.
Which test will be more severe for VCB?
