Interested to Buy Any Domain ? << Click Here >> for more details...
heat can flow from a body at low temperature to a body at
higher temperature only when ........ is supplied from an
external source
A). Voltage B). Current C). work D). Mass
- 7 Answers
- 9753 Views
- BMRCL, I also Faced
- E-Mail Answers
Answer Posted / santhosh s
B) Current
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Hi I'm doing my MBA(3rd semester).I applied for the post of ET conducted by BHEL the last year.I cleared the written and lost in personal interview.Again I wrote the exam this time and cleared the written n yet to take the personal interview.Shall I disclose in the interview about my studies.What shall i say if they ask about my change from studies to job
2 v/500amp/hr to 1.80vpc at 20 degree celsious 2v/5ooamp/hr to 1.75 vpc at 77degree farren .this is the capacity of a battery .what is the meaning of this . can i get a detailed explenation
1) What are your personal strength? 2) What are your personal areas of improvement? 3) What are your expectations from from a particular job? 4) what are your carrier objectives?
What do you mean by a voltage transformer?
In India the supply voltage is 230 volt A.C. During the negative half cycle phase becomes neutral and neutral become phase? or what will happen during negative half cycle? how the electrons flow during positive and negative half cycle?
A powerplant has 8 gensets operating in grid parallel mode. In one genset sometimes there is pf variation and kvar variation. The plant operates in pf mode. When this variation is observed the load is stable, voltage is also stable, freq and genset speed is also stable. How will you check the functioning of pf card. What shall be the ideal output vdc of the pfc, from there it is input to AVR?
What is the slip speed?
Can u Explain about the electronic trivector meter and the use of data converters in them?
can anybody send the rrb chennai &rrb bopal question papers of 2006&2007.My exam is on 12 oct 2008.Its urgent
What is the power factor of an alternator at no load?
why +24 v and -48 v give to BTS? If -48v protect from surge then why we not use -24 v?
explain the types of drives
What willbe change in programming when we use 5/3 solenoid inplace of 5/2 in operating of a cylinder?
What are the commonly used schemes for the bus zone protection?
HOW DO YOU CAN CHECK A 15KV DIODE, WHETHER IT IS OK OR NOT?
