Interested to Buy Any Domain ? << Click Here >> for more details...
how many mmwc are eual to 1kg/sq.cm & can we calculate mmwc
into tph?
- 2 Answers
- 4825 Views
- I also Faced
- E-Mail Answers
Answer Posted / dipak
1kg/sq.cm =10000mmwc
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
Can any body tell me about SAP MAINTINANCE MODULE. WHAT IS its function and application. And study material Source about it. I shall be very thankful.
Why plc require in analog input 4-20amp & 0-10 volt?
how can we tune a PID. If it is by zeiger nichols method..please explain briefly with help of an example.
POSSITIVE PULSE IS APPLIED TO AN INVERTER INPUT.THE TIME FROM THE LEADING EDGE OF THE INPUT TO THE LEADING EDGE OF THE OUTPUT IS 10 ns. THE TIME FROM THE TRAILING EDGE OF THE INPUT TO THE TRYLING EDGE OF THE OUTPUT IS 8 ns. WHAT ARE THE VALUES OF tPLH and tPHL?
Valve positioner and actuators in detail.
Explain about safety integrated level protection? . How it was differ from other protections ?
sir ,iam in dem urgent need of HPCL Paper of Instrumentation Branch plz send me at your earliest convenience at ujjwal_sharma1983@yahoo.com
Coal mill Instruments Equipments for cement plant And process diagram ?
What are the interlocks we have to check during the start up of LP/HP compressor?
What are the type of bonnets in the control valves?
Decibel.
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
where proximity sensor installed on tank in loading arm application
why we take %i0.0 as input for twido plc
In bently nevada vibration monitoring system,what is the reason to maintain the Resistance of the probe + extension cable equal to 95 ohm? If possible explain the basic principle of measurement with detail electronic circuits.
