Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / badhehm
01)Over-current protection
02)Short Circuit Protection
03)Ground fault protection
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
What is the lifetime of a Thyristor? Is there a recommended lifetime for thyristors after which they should be replaced?
which fault is severe and why?between lll fault and lllg fault which fault is severe and y?
In case of generator when we consume more power produces by it why load on generator increase and starts sound more. and how it is adjusted..
What kind of Neutral CT can be placed in 11/0.433KV transformer to be used and what are its specification?
If we have 11 kv RYB Phase single core cable near about. Then wht effect and losses
what is photo voltic cell,& what are the materials associated with that?and any spcifications like volts/cm etc?
explain the what is a drive ? 0 4 which type motor r use in the celling fan..... PCB plannet 2 13 If stator & rotor of a 3-phase induction motor have different no. of poles, will the motor run or not?? types of drives Why dc supply is used for closing and tripping coil of ht breakers. What happen if we use only ups ac supply only. ACC 1 41 how the 3phase induction motor is running in 2phase supply with help of capacitor? 1 33 what is the actual difference betwen constructional details and constructional features? 1 20 how does commutator convert a.c to d.c?
orifice sizing how done, checking & selection
WHAT SHOULD BE THE BEST CURRENT RATINGS (PRIMARY / SECONDARY)FOR A CT INSTALLED AT THE INCOMING 11KV PANE? WILL IT BE CALCULATED ON THE BASES OF MAXIMUM DEMANT VALUE OR ON SUM OF ALL TRANSFORMER'S KVA? NOMALLY MAX DEMAND REPRESENT THE MAXIMUM OPERATING LOAD OF THE PLANT AND TOTAL KVA OF (SAY 5 NUMBERS TRANSFORMERS) REPRESENT THE CONNECTED LOAD. WHICH i.e. MAX DEMAND KVA OR CONNECTED KVA ARE BETTER TO USE FOR CT CURRENT CALCULATION? PLEASE ANSWER.
For a 6.6kV Motor it is recommended to do megger test with 500 V d.c and not more than 5kV d.c but the Hi voltage withstand test should be performed by 12kV AC. Why the dc voltage test should be limited but AC voltage withstand test could be with such a high voltage?
what is the usage of microcontroller in the panel board?
What do you mean by a phase angel of instrument transformer?
If any one's require of phoenix contact like( relay , termilnal block , surge protection device ) , product please contect me 09878206357 chetan verma
How to know the following data of synchronous generator 1. D-Axis Unsaturated Reactance 2. D-Axis Unsaturated Transient Reactance 3. D-Axis Unsaturated Sub - Transient Reactance
fuel-air ratio in a petrol engine fitted with suction carburettor,operating with dirty air filter as compared to clean filter will be
