Interested to Buy Any Domain ? << Click Here >> for more details...
in three phase it represented by R-Y-B.what is full form of
R-Y-B.
- 11 Answers
- 43550 Views
- Sun Pharma, TCS, I also Faced
- E-Mail Answers
Answer Posted / mandip singh
Yes
| Is This Answer Correct ? | 7 Yes | 0 No |
Post New Answer View All Answers
What is the de rating factor of cable? What is the importance of the de rating factor in cable select
if you are in a software company,then why do you want to come in a core company like sail, ntpc(where lots of trouble like tension but you have a good life in a it company) ?
Give the expression for the frequency of oscillations in an op-amp sine wave oscillator?
how to design the heater in temperature control unit to heat 50KL of water?
how to find 5 kilo meter long under ground 33 kv cable fault location if IR VALUE shows 0.05 M ohm @5000 volt.and cable fault locator shows some time fault distance 3 kilo meter ,3.7 kilo meter and some time 1 kilo meter? now how to find the fault location that where is leakage. note--it is tested with 5000 kv megger and insulation resistance is 0.05 M ohm. and some time 0.03 M ohm comes.
nwhat are the main Components of servo motor?
why three phase capacitor takes unbalanced current in capacitor bank?
What are the different types of controllers?
how we can find of current direction(supply comming/out going direction) when a transmission line passing through sides.
how to CHECK CT AND PT AT THE FAULT OCCUR IN GENERATOR RELAY PANEL .
WE know that for Inductor X=2pifL,In DC f=0,then X=0 so,V=IX=0;But In the DC excitation of rotor of AC generator,DC motor field coil which coils are inductor so why does not applying DC voltage short the rotor coil of AC generator and field coil of motor?If it would then DC source might be damaged but it is not happened. Why does the strand conductor of Electrical power transmission line make twist?
What is meant by celling voltage & current in excitor ?
What is kirchoff ’s current law (kcl)?
why we use circuit breakers for switching instead of normal switching device?
How can we increase fuel-power ratio of any DG set?
