Interested to Buy Any Domain ? << Click Here >> for more details...
what is the Space heater? why using in Electrical motor?
- 3 Answers
- 11683 Views
- I also Faced
- E-Mail Answers
Answer Posted / ash
When a motor is built as a "totally enclosed" (TE) unit, no free interchange of air can take place between interior and exterior. That's good protection against entry of solid or liquid contaminants.
But no enclosure can be airtight. As the TE motor heats and cools between "on" and "off," or from day to night, outside air will "breathe", in and out, and the water vapor in that air will condense on interior surfaces of winding and bearings. The result will eventually be insulation failure and bearing corrosion.
To prevent that, the motor's interior needs to be kept warm — above the condensation temperature — whenever it's not running. This is particularly true for motors that run only a few hours a day, are seasonally idle, or are installed in unusually damp locations. It's not a function of motor size or type. The same conditions exist, and will be equally damaging, whether the motor is 1 horsepower or 1000.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
how to calculate the no load current in transformer?
what happen if the load connected to the induction motor is taken away? the same question for synchoronous generator in synch i think that the the exitation voltage will appear on the terminal only if so plz answer me
specify the inbuilt protections in DG
Between educational qualification and practical work experience, give us a brief explanation on your practical experience in your past Endeavour that you performed well to the satisfaction of your past or present employer?
Why cables and busbar both needed in LT Panels?
IN SINGLE PH TRANSFORMER IF LEKAGE IMPEDANCE DROP IS NEGLECTED ,THE FLUX IN THE MAGNETIC CORE and the lekage flux linking a winding are a)proportional to the applied v to the winding i respectively.
what the function breaker failure scheme, how is it operated
A motor running with lenze frequiency inverter stops if I REDUCE SPEED with 25% load.If I run it in High speed and medium speed running smoothly with full load.please help me to solve it.
Sate maximum power transfer theorem?
what is reverse power relay brief explanation and in b/w where it is connected
why the NGR (neutral grounding resistor) always OFF during DG off?
How can we checked Killo Watts of Motor & Alternator?
What is order of the system?
what is reactive power?, why its measured in VA ? is it transient behavior of system?
lamination figures
