Interested to Buy Any Domain ? << Click Here >> for more details...
1.what is bus cuplour and main funtions.
2.what is main function of alternator.
3.how many types of dg oils.
- 11 Answers
- 46611 Views
- Bhel, I also Faced
- E-Mail Answers
Answer Posted / gs kiani
Bus Coupler is a circuit breaker used between two or more buses to couple the buses and retain supply to the load incase of any faliure in one bus or source. Supply is maintained without any power otage or break.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Why can't we take NO LOAD TRIAL of motors having V1 mounting??
how to carry out Magnetizing Current Test on Distribution transformer and what purpose we are doing this test. why transformer rating in always in KVA ? what ispositive, negative, zero sequence impedence? How ElCB tripping if Neutral touch with ground Why AC & DC capacitor are use in UPS ? why motor rating in KW? how to syncronize two dg sets
A 11KV, 1200 A breaker combination fixed in a cubicle for HT motor.Is normally for 11 KV motor fuse is using? if Yes, What range fuse is required?
What's the difference between non break power supply and non break non short break power supply
What is the basis for framing the rules of block diagram reduction technique?
what is the principle of operation of CFL ??
On what basis do you decide the ONAN (Oil Natural air natural) or Dry type transformer for a project?
how we can do the insulation on secondary of ct explain and so that tan delta will within limit
what is the difference between earth leakage and earth fault?
What is the differentional relay...what is the work of this in power Tx. how it is works..
why single CT used in DOL starter power circuit?
Is any AC drive(VFD) had a feature of DC injection braking? if available please mention the detail. i.e drive can supply braking torque when the motor in idle state.
What is the phase relationship between the primary and secondary voltages of a transformer?
is IS says that neutral should be brought to switch box. and this one is a recomended practice
in HT service 3ph 4 wire service Y-phase voltage shows zero . whether it is meter fault? or what be the reason ? if y-ph voltage zero ,can current is recorded? reasons for failure?
