Interested to Buy Any Domain ? << Click Here >> for more details...
What are the different condition monitoring techniques for a motor?
- 1 Answers
- 3569 Views
- DAE, I also Faced
- E-Mail Answers
Answer Posted / ramgan1@gmail.com
the following are the major condition monitring in motors.
running condition
1. load current, PF, RPM, voltage applied to th emotor
2. vibrations of the motor in all three directions, vertical, horizontal, axial
3. bearing vibrations( now days in one meter we can measure the both readings)
off condition
insulations resistance of the motor
winding resistance of the individual coil
inductance of the individual coil
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
what is mean by PIR in circuitbreaker and give me detail of that?
What do you mean by reach and reach the point of the relay?
how does high earth to neutral voltage affects electronic circuit?
Why synchronous motor is used in power factor improvement,dc series in lift
How I calculate the ELCB for circuit breakers?
Maintenance of transformer???
what is the safety points of vaccum circuit breaker.
3phase motor can be used as a Prime mover for alternator.
what is the relation between size of the anteena and wavelenghth of radiated wave
what is laser diodes?
My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I - is the value of AC fault current. t - is the operating time of disconnecting device in seconds. K – is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.
can we use trip light with bus coupler?
Why only sinusoidal ac voltages are generated?why not triangular or sawtooth?
Dear all, how we select the cable size according to current with or without including different correction factor , is there any direct method for sizing of cable...
What is the difference between the impedance percent and impedance voltage ?
