Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / praveen
CVT is used in feeders near substation. Where as PT is used Bus Bars.
I dont think CVT and PT are used on basis of Voltage ratings.. As every substation has both CVT and PT irrespective of voltage ratings at feeder and Bus Bar respectively.
And both their purpose is Protection and Measurement.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
(1)The demand for electricity , the amount of renewable generation available, the amount of fossil fuel generation available and the cost of the fossil fuel generation are shown in table below period(hrs) demand(MW) renewable (MW) fossil- fuel(MW) cost of fossil fuel(MW) 00.00 - 01.00 2000 1800 2000 30 01.00 - 02.00 2300 2500 2000 30 02.00 - 03.00 2500 2700 2100 45 03.00 - 04.00 2900 3100 2100 50 04.00 - 05.00 2700 2600 2500 45 05.00 - 06.00 2400 2000 2700 50 06.00 - 07.00 2200 1800 2000 36 07.00 - 08.00 2100 1600 2000 36 Assuming that the renewable generation incurs zero cost, determine an optimal generation schedule(specifying the amount of renewable generation and fossil fuel generation used in each period, the cost for each period and the overall cost for 8 hours.)
What is speed mode?
What is true sine wave or pure sine wave inverter?? Is it sine wave or step wave?? If it is step wave, waves with how much step is considered as pure sine wave? Is it possible to produce pure sinewave using power electronics?
how harmonics generated in induction furnance? how minimise it?
Define conversion efficiency of a power amplifier. What is its value for class c power amplifier?
can any one suggest paper presentation topies for electrical engg?
what is meant by 3rd hormonics ?
what is circuit recombiner and how it is different from circuit breaker
How grounding is different than earthings?
Is it possible to protect 3phase overload and earth fault of the 3phase system using two CT's.
what is the difference betweem star connected motor & delta connected motor?
How do i right a ladder diagram that has 1 actuator that performs a full stroke followed by a half stroke
What is inrush current?
what happend to DC shunt motor if its field winding insulation becomes slightly weak? will that motor can run on full load or not explain in detail. thanks
Work done in a free expansion process is
