Answer Posted / anbu
The purpose of turning gear is to rotate the shaft to designed min rpm, when the turbine is in shutdown condition. It is used to avoid eccentricity formation due shaft bend or uneven temperature occur ( may be cool in the bottom side) in the shaft. To overcome this, the shaft should not in ideal state. So, some external source is required to rotate the shaft that is turning gear.
Is This Answer Correct ? | 7 Yes | 2 No |
Post New Answer View All Answers
What is least count?
Explain the importance of thermodynamics laws in mechanical engineering?
i require technical question paper which has been asked in last railway recruitment board exam for the post of junior engr.
What is the most important thing you have achieved as an engineer?
What are the causes of liner high temperature?
What are the two basic types of steam turbines?
What is the normal vacuum pressure in a steam turbine atmospheric condenser?
What are the procedures on how to anneal?
Hi, I am Jose. I am an Mehcanical Engineer. I am planning to appear for BHEL ET exam.Can any one help me how to prepare fo this test? Is there any question paper pattern for this test?
what is the velocity considering in lube oil drain line for lube of system for steam turbine?
Explain the differences between pneumatics and hydraulics?
Crankcase oil mist detector
What is burnt-out point ?
how to calculate stiffners position and size in transformer design
tell me about a time when u had too many things to do and u were required opinion prioritized your talks