What does threshold mean?
what does tolerance mean?
- 1 Answers
- 5198 Views
- DEWA, I also Faced
- E-Mail Answers
Answer Posted / euclid
Threshold- The point that must be exceeded to begin producing a given effect or result or to elicit a response.
Tolerance-the permitted variation in some measurement or other characteristic of an object or workpiece.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
plz you help about Que paper of mahagenco previous your,any model paper relad to it{maharastra power genration}
Punj lloyd is coming in our Jadavpur Universtiy campus for campus placement. Please send me some hints about the writtend exam. My email id is subratafriends@gmail.com
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
Good evening all I need a small favour regarding reliance paper i wanna probable sample papers(e&i) of reliance. if any of u have any idea about dis then plz mail me back.i belongs to electronics and instrumentation engg.so i need e&i papers. thanking u....
can any one tell me when ongc placement test and its forms is available????/ pls tell me if u know
can any send me a forbes marshall dtron 316 manual
plz send me general of ongc
use of split range ? where it is used ? in which control loop it is used ?
Can any one send me IOCL instrumentation question papers.. i dont know the pattern of the questions and what to prepare can any one help me on this .. my email id is anwarnishil@gmail.com
pls suggest suitable MOC of diaphragm for pressure measurement of UREA grade solution service fluid.
any body who gone thru recent iocl interview.INSTRUMENTATION questions. I need.
Questions on flow meters,few questions on HART protocol,
send me last 5 years questions asked in rrb chennai, for section engineer
sir, give me placement papers and interview quistion of birla group company of copper.
please any body have most important data for study for saudi aramco test of instrument QC thanks email shahnaveedullah@gmail.com
