Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / aditya
over frequency occurs when the RPM of prime mover goes above the rated speed. This protection is basically for prime mover and gives a trip signal to the prime mover in case of overspeed so that the centrifugal forces dont damage the prime mover and alternator rotor. This is generally a result of faulty speed governor or sudden throw off or throw in of large magnitude. In addition overspeeding will also result in increase of supply frequency. certian electronic equipments are very sensitive to freq and get damaged hence over freq protection is given.
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
what do u understand about FACTS? how they are useful?
If Dg set load increase 25%, How much increase fuel Consumption (15 kva 2 cylinder DG set)
Define conversion efficiency of a power amplifier.
A 15 kw squirrel cage motor having a maximum efficiency of 90% on a continuous full load has temperature rise of 42 degrees celcius after 30 min and 52 degrees celcius after 1 hr under the above operation conditions. a) calculate its final steady state temperature rise on continuous load and the heating time constatnt. b) if the motor is operated on a short load for 9 min estimate its temperature rise. c) calculate the maximum overload that can be applied on a short, 9 min rating so that the temperature rise is the same as the final steady state temperature rise on continuous load.
What is the function of NER and NET?
IF HT CAPACITOR IN ON POSITION IS THERE ANY LOSSES I.S I SQURE OCCURS IN THE SYSTEM
What is the general system requirement of alternator?
how can we change the polarity of Alternating current rapidly? how frequency of ac can be controlled and changed easily?
How to test IR testing & magnetic balance test
hey guys i scored 910 on GRE and 67 on TOEFL respectively.I have an aggregate of about 74%in my B tech.For which colleges should i apply for an MS program in electrical engineering.I am looking for colleges in NJ,SC,NC,GEORGIA, NY. Please reply with a good response.....
what is differnce btwen lll and lllg faults
Why MCCB is Getting tripped sometimes when there is no load in the Midnight ?
Will any motor burn if voltage provided is lesser than the rated voltage???? If yes, then how is speed control possible with voltage control
why servomotor motor? where i apply for best output?
how calculated Transformer losses.
