Interested to Buy Any Domain ? << Click Here >> for more details...
How i measured Bus bars weight without wighting ?
- 3 Answers
- 4631 Views
- Encom, I also Faced
- E-Mail Answers
Answer Posted / md.yeasir arafat
Weight = (Width * Thikness)mm /166*2.2046 = Ans Kg/ft
. Suppose bus bar width 80mm and Thikness 10mm. So the weight of this busbar = (80*10)/166*2.2046 =17.488 kg/ft. If busbar size 2 ft the total weight will be = 2*17.488 =34.976kg.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
I have a current transformer with 1 main reading meter with transformer outside the building and a control panel having 5 CT reading meters with black round coils inside the building. I want to know, A) when current pass through the Transformers, will the current be reduced or be the same and after that B) when current pass through the CT meters with black round coils, will the current be reduced or be the same. C) in the above process will the reading of the main meter be same or different, from the total reading of all the 5 CT meters.
Do inductive loads have distorted current waveforms ?
What is the function of RCBO? What are the different sensitivity ratings & each application?
How relay coordination has to be done? what are the inputs are required for this? Please explain this with calculation method?
what is effect of leading power facter on the system and billing
I have one ct of ratio 3000-2000/1 Amp its knee point voltage mentioned on name plate is 500-333/30mA-50mA at Vk/2. in secondary box there is three terminal named 1S1, 1S2, 1S3 then on which terminal obtained the knee point voltage ie 1S1-1S2 OR 1S1-1S3 & also specify the knee point voltage for the ratio 3000 from name plate.
How to select, design,size & calculate for 11 KV/33KV/66KV/132KV/220 KV/440 KV circuit breaker for HT side of transformer protection/HT distribution protection?
Can clean earth cable be considered as low current cable
What is shunt voltage and u v voltage witch one best
why various test are performed on electrical panels & power cables before commissioning on site & what are these test???
Explain what are inter-poles and why they are required in a dc machine.
1- What is the Polarization Index number be good for 15KV 3c#500MCM electrical cable? 2- Can I use the IEEE Std 43-2000 to perfom the PI test? Thanks
How would your past experience translate into success in this job?
plz tell me,ht and lt panel terminals in substations explain beiefly
How to calculate the electrical load for a standard telecom BTS shelter and choose the DG set capacity for the same load?
