Interested to Buy Any Domain ? << Click Here >> for more details...
why we are using orfice plate?
then difference between orfice 7 nozzle plate?
- 1 Answers
- 4416 Views
- Flour Tech Engineers (P) Ltd, I also Faced
- E-Mail Answers
Answer Posted / kranti1986
to create pressure difference in a flow line. withe the pressure difference we can measure the flow rate
| Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
what will the sending unit in the fuel gauge utilizes?
send me HPCL paper
how u calibrate pneumatic n motorized c/v?
please tel me the calibration of pneumatic controler.
what is instrument philosophy
what is the reason while warning lamp is on while the engine is cranking?
Where is wet leg is used?
can anyone tell me about the basic concepts to consider before to start a PLC panel wiring
please send the drdo exam paper
What is the difference between mmwc and mmwg?
Calibration of controller (pneumatic)
what is commisioning procedure,2)what is is the main work in commisioning in the field tx to dcs, plz send me detail
PT RTD Range: -200 to 500 degree celsius If I configured in DCS Lower range and Upper range . In face plate it shows red colour due to overa range how was the characteristics look If the temperature is more than operating range. how was the characteristics look . whether its in Resistance vs Temperature curve is Linear or Non linear
what is interface level and how it is calibrate?
A DP transmitter is used to measure the level of an open tank. The drain line of the tank is connected to a control valve, and is configured as, if the level of the tank is 90% the valve should get open 10%. And if the tank level is 10%, the valve should get open 90%. Draw wiring diagram and explain how to configure DP transmitter and control valve using HART communicator. If the span error at output is 1%, what will be the %opening of the control valve at 60% level of the tank?
