Before erect the instrument what should you do?
- 3 Answers
- 4121 Views
- L&T, I also Faced
- E-Mail Answers
Answer Posted / fazil
one should have work permit..operator will control the signal manually.. close primary valve and manifold also
drain existing liquid or gas by drain plug.
remove termination and glanding also tape it to avoid short.then you can remove instruments
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
hi i am eswar i want to know the instrumentation interview questations for eil(engineers india ltd) i have applied for engineer post in eil please help in this.my mail id eswar310@gmail.com
For crude application in floating roof tank, how to calibrate a DP Transmitter? How is the floating roof weight considered?
What is instrumentation control?
the whole paper was based on Transducers..questions like define repeatability, error,accuracy,precision..den there were many q. on the conversion of Pa to mmHg and other units.. also..der wer few Q. on some level sensors(with diagram)
There are many type of control cable like pair,core,tried, What are defination each one
What is Alpha & Beta fctors related to Orifice Plate & its relation with flow?
what is the PC interface and software for connection to ABB logic module “ LM011-CE18RAC “ ( for Programming ) ??
what is IEC code in cables & how to selecting cables?
Good evening all I need a small favour regarding reliance paper i wanna probable sample papers(e&i) of reliance. if any of u have any idea about dis then plz mail me back.i belongs to electronics and instrumentation engg.so i need e&i papers. thanking u....
Which are all the commonly used Bordon tubes in the pressure gauges. Do any one use ASTM A 312 tubes for this purpose?
If relative y axis vibration sensor is by passed, and relative x axis and absolute sensor is left working. how much monitoring i would have risked?
Why we are using reverse action in displacer types level transmitters on some Vessels?
How hart protocol can be connected with control valves?
give me the formula for analog to digital converter and also d to a converter
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
