Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / rajan
Onely HT side tape volage high current low copper size less BUT LV side current high voltage low copper size ingrese
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
why would the rotor rotate at sub synchronous speed against the direction of rotating flux when d rotor of 3 phase IM is connected to 3 phase balanced supply and the stator windings are shortcircuited ??
what happen if field of dc shunt motor opens? what is function of putting res. in parallel to one phase of 3 phase IM? the power supplied by 5A source in circuit is given by------Watt.
grr resistance & contrator malt continuous
What are books to be referred for KPTCL exam?
how works inductive &capacitive sensors?
how to find motors H.P. whout any rating? (only give you a motor and multimeter)
why not starting switch first connect in direct on line starter?????
either water sensor or flow meter,how we observe the water level, f any other equipment are in market ?
what are the difference between AC lamp and DC lamp
why Y CONNECTION IS BETTER INTERMS OF EFFICIENCY AND P.F FOR A LAOD LESS THAN 40% AND WHY AFTER DELTA IS BETTER FOR > 40%
I am about to write exam in RRB bangalore for the post of section engineer.please provide me with previous exam questions
How to do bus bar short circuit calculation for 230KV/11kv, 60 MVA Substation?
whats the differece between Exd and Exe
As per standard, transformer body earthing and other Equipment earthing (Equipment earthing) did not connect. but in LT side termination we are doing metal glanding in both side Transformer to PCC Panel through armoured cable, now X'mer body earthing and PCC Pane earthing (Equipment earthing) both are connect.is this safe for X'mer or other equipment?
hi frnds what is meant by harmonics & what is meant by third hormonics,where its will occur ?thank u
