why shear is not considered in limit state of serviceability??
Answer Posted / nandan kumar
design of concrete structure by limit state method is generally on two criteria (!)limit state of failure and (2) limit state of serviceability . the shear criteria is the consider in failure criteria because due to increase shear above permissible value the failure of structure will occur
.For this region shear design is not done for serviceability criteria
Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
I want to know about rolling margin of steel :- For eg. If 2nos. bundle of 8mm dia steel with17 rods each of length 12m comes to store. During testing of 1m rod of each bundle it was found that 1rod has weight .405kg/m while other has .385kg/m. Now what will happen in case of steel payment and measurement payment ? Regards,
Under what circumstances should pot bearings be used instead of elastomeric bearings?
can i make bricks using M10 grade concrete ? and what would be the cost of a brick if we use m10 grade concrete sand and aggregates ??
5. Two long boundary walls run parallel to each other at a center to center distance of 1 meter apart. The width and height of the first wall are 0.30 m and 2.5m respectively. While those of the second are respectively 0.18m and 3.5m. Plot the distribution of vertical stress intensity due to walls on a horizontal plane, 1m below ground level. The walls have negligible depth of foundation and are made of brick masonry (y = 19.2 kN/m cu)
How to identify the vitrified tile and ceramic tile by observation only after executing the job.
What are the steps involved in the concreting process?
what is the weight of 6000 psi concrete in lb/cft?
specifications of fe500 steel
what is civil enginnering & what you need of this course?
Whats the meanig of ,'K' VALUE in the case of soil.....
1) write Short notes about Shellow & Deep well? 2) What is the full form of SPT & SMB? write short notes. 3) write short notes about efficiency of Riveted joint.
resins are not soluble in water soluble in spirit used in varnish left behind on evoporation of oil
how many digree of freedom in four bar chain
is there any thumb rule for calculating construction cost of the building with pile foundation per sft. area?
what is the procedure involved in preparing mix design of m15 grade as per IS-10262-1982