Answer Posted / sandeep
percentage=25/4*ma-25
when ma=4,percentage=0
when ma=20,percentage=100
| Is This Answer Correct ? | 7 Yes | 1 No |
Post New Answer View All Answers
Describe how to use megger to measure the earth resistance and insulation resistance
What is the use of gauge?
In dcs panel we are using diff type of modules ?what is module ? what is the use of modules ?diff type of module?
What is force balance principle? State some of its’ advantages.
Where are oxygen analysers installed in cfbc boilers? What are their usual readings?
How a conductivity sensor & analyzer work at boiler, whats the principle & science is beyond this,How conductivity sensor sence & convert signal & move toward analyzer & analyzer show reading in percent? also what is temperature compensate option in conductivity analyzer
control panel design guidelines
Calculate the maximum pressure drop that can be allowed to occur across a control valve, so that we can prevent cavitation / flashing from occurring. Use the following formula: Δ P allow = Km (P1 – PvapourA) where, Δ P allow - the maximum allowable differential pressure for sizing purposes, or terminal pressure drop; Km- the valve recovery coefficient from the manufacturer’s catalogue; P1 - absolute inlet fluid pressure; PvapourA - absolute fluid vapour pressure at the inlet temperature; Use Atmospheric pressure = 101.3 kPa, P1 = 1200 kPa(g), PvapourA = 4 kPa, KM = 0.72
How to interfacing microcontroller with a DC motor
I want to buy a seal kit of a pneumatic power cylinder.But I don't know it's specification.So please help me to know its specification.
Questions on flow meters,few questions on HART protocol,
what is a good line as ic engineer as maintenance ,oc, project, calibration ,validation engineer?
what about your moleg in pogrees with company
How to calibration a control valve?
Difference between dcs and plc including date processing and architecture.
