What is the difference between Split ring and slip ring?
Answer Posted / shahzaib/zeeshan
split ring is mirror like shape. while slip ring is circle like shape. split ring is used in d.c motor for reversing the direction of current after each half revolution. on the other hand slip ring is used to keep the direction of current in same senses
| Is This Answer Correct ? | 2 Yes | 3 No |
Post New Answer View All Answers
there is an alternator 480 k.w, 400v,50hz, 4-wire running on load having leakage alternator body earthed current 38 A. is it within acceptable limit? if yes then give reference if no then how to bring within specified limit
why asa method ZPF method is more accurate than ASA method?
who many types of fire explane with exmple
a)In a 3-phase 4-wire circuit, a circuit breaker is selected to protect the circuit whose highest fault level is 6.6 MVA. Determine the required minimum breaking capacity in kA. (Note: Covert 3-phase power in terms of kA to find answer.) b)Using the below, determine the required minimum making capacity in kA as a “peak value”. Rate breaking capacity (Icn) ka: Icn<= 1.5 Factor = 1.41 1.5
draw the block diagram of fire alarm?
DG cranking voltage?
What is the function of electron gun used in crt?
what will happen if frequency is below 50 hz?
WHAT ARE THE EFFECTS OF SERIES RESONANCE AND PARALLEL RESONANCE ON THE CIRCUITS PARAMETERS?
what is the excess air in furnace
What is main cause of cable's terminal point burned in Lug on high temperature although lug and cable selection is ok as per stantard and also tightness is ok as per situation. so please take in deep and tell correct answer thanku.
What is Auto Mains Failure Panel & Auto Synchronizing Panel
Can you explain about TEE protection scheme?
What is the general power consumption rating of CPU CRT type and Flat type, Monitor,Printer, projector, Scanner?
what questions will be asked for 11/33KV licence interview APSEB hyderabad. Can any one share question and answers.