Interested to Buy Any Domain ? << Click Here >> for more details...
What is difference between loop and zone ?
- 5 Answers
- 13984 Views
- Adgas, Bilt, I also Faced
- E-Mail Answers
Answer Posted / dsa
Zones are based on hazardous area classifications, zones r catergorized based on explosive gases which could be present in the area.
Loop are basically open or closed. Basically in instrumentation a loop is defined from the starting point which is sensor to the end point I.e system. This irrelevant to whatever system u use.
If your question isn't answered kindly elaborate or provide more details and not just ask general questions!
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
the pump holds on run indication into the dcs and filed local control panel remote push button condition operaton wrong like when the push button pushing conditions the pump is off and the push button release condition the pump is on totally opposite condition . And control room inside give the stop command into dcs just 1secon relay engage and again normal condition. How can I slove
send me HPCL paper
can u briefly explain aboutan aryton shunt multirange DC ammeter?
how to calculate orifice sizing? and tell me if pipe size bet 50mm t0 200mm then we can use pipe flange??? and above 250mm pipe size should i use D & D/2 Flange? is it right or wrong?
why direct mounted pressure transmitters is always installed with DBB ( double bleed block) valve in process line or top of the tanks ?
HOW TO SOLVE PROBLEM WITH ENRAF LEVEL TRANSMITTER 854 ATG THAT PASSWARD DO NOT Exist INTO TRANSMITTER TO ADJUST LEVEL WITH PORTABLE PET 847, WRITTEN WRONG PASSWORD , I AM SURE THAT DEFAULT PASSWARD (W2=ENRAF2) IS THIS TRANSMITTER NEED TO REPLACE SOFTWARE AND HOW?
when placing a vent or drain hole on an orifice plate should you measure from the center of the bore up or down for the vent placement?
How u measure the massflow in orifice flow measurement techniques
can anyone guide me how to get any of the previous year GAIL question papers? are they available? 0n 2nd august i have to take the written test.
types of cable..? Use of every types of cable..?
i have done DAE in Instrumentation and Process Control. i have applied for an apprentice training in chemical company after three day my interview will be conduct but i need more information about industrial process control and controller. my e mail is imran_dilsetu@yahoo.com please tell me interview question relative to instrumentation ?
How many interlocks at turbine side?
hi sir yhis is zahid ali i am preparing for the jspl at oct.4.please send me the recently updated sample paper.
Define the terms Accuracy, precission, Spam, process tolerance while doing calibration of an instrument? Explaini with an example?
What are the interlocks we have to check during the start up of LP/HP compressor?
