Interested to Buy Any Domain ? << Click Here >> for more details...
How to obtain B license from TNEB license board. What is eligibility?
- 11 Answers
- 26913 Views
- Core, Reliance, I also Faced
- E-Mail Answers
Answer Posted / prg
one cannot get b licence from tneb but from electrical licencing board by providing experience certificates and working in HT, minimum qualification required is completing ITI.
| Is This Answer Correct ? | 49 Yes | 12 No |
Post New Answer View All Answers
what type of questions are asked and howmwny questions belong this catagory?
what is the difference between 2 way and 4 pole selector switch???
What are hrc fuses and where it is used?
Why delta star trformers are used for lighting loads?
What are steps to be taken while designing of DYN11 distribution transformer to achieve magnetising balance?
how to determine the cable size...pls explain me with the formula taking particular load....does the factors like impedance & short circuit rating influence the cable size, if so how....
On 400 amp factory load how kvarh capacitors provide
Direction of flow of active power and reactive power with logic?
In our factory so many iron pillors are exists for supporting the shed/Hangar. If do more no of earthings at one piller instead of doing more earth pits in many locations and running earth strip around the hanger, I can save the money. Please suggest this method is acceptable as per Is specifications though the Earth resitance of the farthest piller is with in the limits as per IS specifications.
How does "OUT OF STEP" relay ,for Synchronous motor protection, work?
How to design inductive load for 3 phase 440v and maximum 5 amps for star or delta? Can we use a 15kW, 1450rpm motor for 15kW, 960rpm apllication?If yes.how......n.if thesame motor used what`s it`s sideeefect.
If mutual flux is 1.2wb & power factor is 0.8 lag , then what is the Useful flux of a transformer?
Can anybody inform me about the pattern of ECIL GET( Graduate Engineers Trainee) interview for Electrical students? Will there be HR round as well? I thought of preparing for 2 to 3 subjects thoroughly. Will it be sufficient? Please share your thoughts.
if 6 earth pit value is 1.5 ohm then what should be the number of earth pit to make the value .8 ohm
How impulse levels are calculated that for 11kV impulse is 75kvp, for 24kV impulse is 125kvp ?
